Thingiverse
Angled Flashforge Creator Pro Filament Guide
by R_Boe
7
Downloads
3
Likes
0
Makes
Yet another filament guide for a FF Creator Pro:
My version has an angled outlet of the guiding tubes to allow a better path to the extruders. The tubes slip into the guide in a soft curve. The filament is routed by the tubes and won't rub on the printed guide in the curved section.
The interface towards the backpanel of the printer has limit stops at the top to inhibit that the guide slides down when fiddeling with the filament or the guiding tubes.
The studs at the bottom (the rendering shows the part upside down in printing orientation) can be used to attach the threaded filament filters by
ppyromann (https://www.thingiverse.com/thing:153807).
Files:
I've added two versions:
One with additional small discs as a warp protection if you aren't using other method to prevent warping and one w/o them.
My version has an angled outlet of the guiding tubes to allow a better path to the extruders. The tubes slip into the guide in a soft curve. The filament is routed by the tubes and won't rub on the printed guide in the curved section.
The interface towards the backpanel of the printer has limit stops at the top to inhibit that the guide slides down when fiddeling with the filament or the guiding tubes.
The studs at the bottom (the rendering shows the part upside down in printing orientation) can be used to attach the threaded filament filters by
ppyromann (https://www.thingiverse.com/thing:153807).
Files:
I've added two versions:
One with additional small discs as a warp protection if you aren't using other method to prevent warping and one w/o them.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!