AnkerMake M5 Tool Case Holder

This is a holder for the plastic tools case that comes with the AnkerMake M5. It clamps to top horizontal bar.

The clamp is intended to be tight, so expect some resistance when attaching. If you're worried about breakage, you can sand the claws of the clamp down a little bit until you're comfortable enough to push it in. Regardless, a swift, firm push is usually all that's needed. :-)

Printed with pretty much default settings in the AnkerMake slicer. Normal speed, 0.2 mm layer height, etc.. Two differences:
- I'd recommend a higher infill % to ensure the clamp is strong. I personally printed at 60%, but YMMV.
- Make sure supports are generated for the clamp. Default zigzag settings should be fine. The underside of the clamp won't look pristine, but it won't matter since it sits on the bar, out of sight.