MakerWorld
Puzzles
Model downloaden
Annoying Easter Egg - Single Extruder
39
Downloads
26
Likes
18
Makes
This is a fun one! I call it the “Annoying Easter Egg” because you have to remove the middle flower, which is the key, and remove 16 screws. I have all the parts on separate plates, and stripes are listed in order from top to bottom. Glue in your pieces and then have at it! Pretty simple and a lot of fun. If you aren't using my print profile, print all the parts once except:Screw: 16xFlower Dot: 3xDot: 11 NOTE: The plate with the screws and stripes does NOT need to be printed with supports. It adds a lot of print time. Also the key only fits one way! So take that into consideration.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
