Thingiverse
Another Decorative Box
by Winslow
174
Downloads
120
Likes
0
Makes
Approx. dimensions:
10cm. x 6.75cm. x 9cm. high.
The model in the photos was printed on my Makerbot Replicator+ at the default setting of 10% infill and a layer height of 0.2mm. I used a raft, but no supports are needed when the parts are printed in the same orientation as the STL files shown here.
See more of my designs at https://www.thingiverse.com/Winslow/designs
10cm. x 6.75cm. x 9cm. high.
The model in the photos was printed on my Makerbot Replicator+ at the default setting of 10% infill and a layer height of 0.2mm. I used a raft, but no supports are needed when the parts are printed in the same orientation as the STL files shown here.
See more of my designs at https://www.thingiverse.com/Winslow/designs
Winslow also publishes on
14 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!