Thingiverse
Another multi-filament spool
von MattFa
4
Downloads
4
Likes
0
Makes
A simple spool for filament leftovers and samples.
In OpenScad you can set the number of sections and the diameters or simply print the stl files 6 times for a spool. Spola1 is 5 filaments (tested and proven), Spola1f is a single section, but I haven't printed it yet.
You insert the flat part into the slot of the next section and tie them with one or two cable ties.
The design uses arpruss' [bezier.scad](https://www.thingiverse.com/thing:2207518), thank you, [arpruss](https://www.thingiverse.com/arpruss/designs)!
It is kind of an overkill, but quite practical.
In OpenScad you can set the number of sections and the diameters or simply print the stl files 6 times for a spool. Spola1 is 5 filaments (tested and proven), Spola1f is a single section, but I haven't printed it yet.
You insert the flat part into the slot of the next section and tie them with one or two cable ties.
The design uses arpruss' [bezier.scad](https://www.thingiverse.com/thing:2207518), thank you, [arpruss](https://www.thingiverse.com/arpruss/designs)!
It is kind of an overkill, but quite practical.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
