Anova Collar

This is a very simple collar to go on an Anova Sous Vide Precision Cooker. It is meant to replace the clamp that comes with the Anova, when inserting the Anova in a hole. An excellent and very low-heat-loss container for sous vide is a cooler in whatevery size you need. Use a HDPE cutting board to make a cover for the cooler and cut a hole to fit the Anova. Or just cut the hole direcly in the cooler lid. Put this collar on the Anova, and just slip the Anova into the hole and thence into the water. The collar will sit against the lid, keeping the Anova upright.

Nothing special about printing. Use ABS or PETG, not PLA (PLA can't stand even low heat).