Thingiverse
Antenna Mount - 90 Degree
di flexo_fpv
8
Download
3
Likes
0
Makes
This is a pair of antenna mounts, designed for the top and bottom of a wing or fuselage. The top side mount is 60 Degrees, the bottom is 30. They are designed to accept an antenna tube that gets super glued into place.
To install, slit the foam, pre-fit the mount, then glue into place. The tube should be .125" or less and CA glue can take up any remaining space.
Print in a vertical orientation with no supports, but a raft is suggested because of the small base contact
To install, slit the foam, pre-fit the mount, then glue into place. The tube should be .125" or less and CA glue can take up any remaining space.
Print in a vertical orientation with no supports, but a raft is suggested because of the small base contact
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
