Thingiverse
Antenna Support
por albertk836
4
Descargas
1
Likes
0
Makes
The 9/32" OD BNC antennas I have for my CR-1 will not stay upright.
I created a support that is held into place by the head of the lid mounting screw. (the support slips around the head, not mounted under it, for easy removal.)
Like the Power Lock I created earlier, (shown in the picture), I added a small 1/16" hole to attach a small string to help from it getting lost.
The small lip shown on the .stl is too small to print so I did not bother removing it.
Have Fun!
I created a support that is held into place by the head of the lid mounting screw. (the support slips around the head, not mounted under it, for easy removal.)
Like the Power Lock I created earlier, (shown in the picture), I added a small 1/16" hole to attach a small string to help from it getting lost.
The small lip shown on the .stl is too small to print so I did not bother removing it.
Have Fun!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
