Thingiverse
Anti-Spit Vape Tip
von JesusGoggles
2
Downloads
3
Likes
0
Makes
A replacement tip for your vape device tank.
Use an O-Ring from an old drip-tip, or a small elastic band around the bottom works very well to lock it into place.
I strongly suggest PETG as a material. I recommend not using supports unless they are the soluble kind. I printed it using an Ender 5S1 running Klipper at 70-100mm/s @5000mm/s^2 YMMV
Use an O-Ring from an old drip-tip, or a small elastic band around the bottom works very well to lock it into place.
I strongly suggest PETG as a material. I recommend not using supports unless they are the soluble kind. I printed it using an Ender 5S1 running Klipper at 70-100mm/s @5000mm/s^2 YMMV
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
