MakerWorld
Decor
Go to Model
Antler
15
Downloads
10
Likes
4
Makes
I 3D scanned an antler I recently found in my backyard, and this is the result 🦌✨ It took quite a bit of work to get it printing correctly. I had to use manual supports to make sure everything came out clean and consistent. I’m sure someone with more experience in Bambu Studio could optimize the supports and improve the print profile even further, but in its current state it prints reliably and consistently 👍 Just be aware that it does require supports. This print was made using Bambu Lab Basic Blue PLA, and the final result came out looking great Boost Me
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
