Antweight Pusher

This is not so much a remix but it is a ground up redesign of Aldwin's antweight bot called plover. All parts will now print without support and there is slightly more useable space inside for the electronics to fit.
The lid is no longer held on with screws but is now held on by friction and the little nubs on the pillars of the lid, This means that the battery connector can be used as the isolator and there is no longer any need for a switch. The receiver and esc's I use have led's on them and are easily seen through the plastic so there is no need for a separate power led either.
Also the slight increase in space inside the bot has allowed to more easily use a 260mah battery pack and as you can see in the photo there is enough space to go even bigger than 260mah if you wish to.
Weight wise my complete bot comes in at around 120gm, could save a bit by tidying up the wireing aswell so it is possible to print with higher infill than i did.


UPDATE: I have tweaked the lid slight