Anycubic Chiron Hemera Mount

E3D Hemera mount for the Anycubic Chiron. This is a bolt on mount that works with the stock X axis carriage. There is an included mount for the stock bed level probe but you will need to use longer screws for the fan and extend the probe wires to use it.

I also included the Fusion 360 file in case you want to modify anything to your needs.

Nozzle Z height should be very close to stock. You may need to tweak the X and Y offset a little bit.

Supports should be on build plate only to support the under side of the screw holes.

Build Notes:
There is an extra hole under the extruder motor that was intended to be used with a heat set threaded insert that ended up not being necessary. The two screw holes where the stock extruder mounts should use M3 nuts on the back side.

You must install the motor to the mount without the extruder attached then mount that assembly to the carriage. The extruder can be mounted to the motor after the motor and mount are installed onto the carriag