Anycubic Chiron Light System

This is my new design to add a light on the X-Axis of the Anycubic Chiron 3D printer.

To make this you require the following materials:

-PLA/ABS/PETG for the support that holds the LED Strip (Black it's suggested)
-PLA/PETG TRANSPARENT COLOR (Transparent neutral is better) for the Light diffusor
-LED Strip 35cm lenght
-3 screws M4
-3 T-nuts
-2 couple of 2 wires connectors
-about 60cm of wires red/black AWG26 or similar type (black is better)


If you use a 24V volt you are ok. If you have a 12V LED Strip (like me) You need also a StepDown power supply (3 euros in internet) to transform thw 24V to 12 V

You can take the power directly from the head box of the Chiron with the red/black wires and following the cable path (chain guide) to the light system.

In the Head Block you can find the +24V on pins 2,4,6 or 8 and the GND(-) on pins 14 or 15 of the BIG-RED connector that connects the headblock to the Chiron Body. The Pin1 is marked on the PCB with a square. The pins