Thingiverse
Anycubic I3 Mega cable holder
door harleyjunior
32
Downloads
14
Likes
2
Makes
PL:
Zaprojektowałem inna wersję zaślepki na przewody extrudera. Druk wykonany bez podpór, przy prędkości 60. Otwory w projekcie mają 4,5mm, śrubki w moim przypadku to ok 5mm, wiec delikatnie trzeba podpiłować, aby weszło na wcisk. Głównym założeniem projektu była bezinwazyjność w konstrukcję.
ENG:
I designed a different version of the extruder cable end cap. Printing made without supports, at 60 speeds. The holes in the project are 4.5mm, in my case the screws are about 5mm, so you have to gently band yourself to press. The main assumption of the project was non-invasiveness in construction.
Zaprojektowałem inna wersję zaślepki na przewody extrudera. Druk wykonany bez podpór, przy prędkości 60. Otwory w projekcie mają 4,5mm, śrubki w moim przypadku to ok 5mm, wiec delikatnie trzeba podpiłować, aby weszło na wcisk. Głównym założeniem projektu była bezinwazyjność w konstrukcję.
ENG:
I designed a different version of the extruder cable end cap. Printing made without supports, at 60 speeds. The holes in the project are 4.5mm, in my case the screws are about 5mm, so you have to gently band yourself to press. The main assumption of the project was non-invasiveness in construction.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!