AnyCubic i3 Mega Clip-On Box

This is inspired by another equipment box for the Anycubic i3 Mega on Thingiverse, but I've created it from scratch with a few notable design differences.1) The whole thing clips together and then clips to the printer with proper working tolerances, and no glue or special tools required (My main point of making this).2) The width of the box is pretty much exactly a quarter of the available space on top of the printer, so if you run out of space you can print up to three more (in theory) and they should all fit without leaving any wasted space. (untested)3) The front of the bottom of the box is flat rather than angled leaving a bit more room in that direction.4) More Attractive (IMO). Optional AnyCubic logo. (I have included a model with logo, and one without)Assembly Instructions:Print the box and two clipsInsert bowtie shaped post on clip in to corresponding hole on box, then rotate until the push-clip lines up with the hole.Push the push-clip in to the hole. Push carefully from both