Thingiverse
Anycubic i3 Mega Flex Extruders
by MikeTitor
6
Downloads
0
Likes
0
Makes
Designed an ultra high tolerance extruder for flexible materials and to work with my direct drive mount system.
Compared to previous extruders I have downloaded and tested:
The spacing between the drive gear and guide wheel is extremely small.
The thicker arm height increases spring tension slightly.
The filament hole is precisely aligned with the travel path.
I have provided 2 variants on the design.
The "For Tube Connector" has a 6mm hole to thread a PTFE locking connector into. For use with bowden setups, or V1 of my direct drive bracket.
The "PTFE Lined No Connector" version has a 2mm hole for 15mm of PTF tube. This lines the majority of the inside of the extruder with low friction material. I recommend using this version with my V2 direct drive mount.
Direct Drive Mounts
https://www.thingiverse.com/thing:4356521
Compared to previous extruders I have downloaded and tested:
The spacing between the drive gear and guide wheel is extremely small.
The thicker arm height increases spring tension slightly.
The filament hole is precisely aligned with the travel path.
I have provided 2 variants on the design.
The "For Tube Connector" has a 6mm hole to thread a PTFE locking connector into. For use with bowden setups, or V1 of my direct drive bracket.
The "PTFE Lined No Connector" version has a 2mm hole for 15mm of PTF tube. This lines the majority of the inside of the extruder with low friction material. I recommend using this version with my V2 direct drive mount.
Direct Drive Mounts
https://www.thingiverse.com/thing:4356521
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
