Anycubic I3 Mega Garbage Box -Upgrade-

Hi!
I really liked the trash can design (https://www.thingiverse.com/thing:2835257) for my Anycubic i3 Mega
I printed it and used it for a while, I got a lot of pleasure from it, but only as long as the basket along with the garbage did not fall to the floor from a height of 1 meter :)
After about the fifth fall, I decided that I could not take it anymore and made a simple revision of this trash can.
This is a common bracket that is mounted on two screws. Print time is 10 minutes.
You will also need to cut off the near T-shaped protrusion on the bracket with a knife (see the photo), and two more M3 screws 4-5 mm long.

-------------------

Привет!
Мне очень понравился дизайн корзины для мусора (https://www.thingiverse.com/thing:2835257) для моего Anycubic i3 Mega
Я это напечатал и пользовался какое-то время, получал от этого большое удовольствие, но только до тех пор, пока корзина вместе с мусором не падала на пол с высоты 1 метр :)
После примерно пятого падения я решил, чт