Anycubic i3 Mega Nozzle Rack (M6)

When I was looking for a nozzle rack, I did find standalone racks, and racks that attached to other printers, but none that attached to the Anycubic i3 Mega. Since I have very limited space around my printer, it is convenient for me to have things attached to it... so here's a nozzle rack. The one that I printed is the one that goes on the left side, and has numbered labels to show which nozzle goes where. The numbers are basically the nozzles that I have, and a couple that I intend to get. If you have different nozzles, you can optionally print the version with no numbers and find your own way to label it. For the version of this rack that goes on the right hand side, I'm pretty sure it should work fine, but I didn't actually print it. To make it I mirrored the clip (which should be enough) and for the rack I mirrored the threads and the numbers (on the numbered version) and then mirrored the whole part bringing the threads and numbers back to the correct direction. I think that should do it. I have designed this so that the clip stays on the printer all the time, but the rack can be slid out from the clip and removed. I thought that would be convenient. The nozzles themselves actually thread in to the rack - I did this because I didn't want the chance of dropping the rack when I detached it from the clip, and dropping nozzles all over the place. The threads are M6 which works with the stock nozzles that fit this printer and most nozzles that I have seen. Final thoughts: Probably a good idea to make sure your nozzles are fully cooled before trying to thread them in to the rack. If you like this design, consider a tip or post a make! Print instructions Supports: NoResolution: 0.1 (rack), 0.2 (clip)Infill: 25% GyroidFilament: Creality PLA Black Notes: Be sure to print the rack at as low a layer height as you are willing to wait for as it will ensure the threads work correctly. I printed the rack at 0.1 layer height with 25% gyroid infill, and it took about 3.5 hours.