Anycubic kobra S1 vent riser

Here finally is a sturdy STRONG Vent riser for the ANYCUBIC KOBRA S1! Frame printed in PETG and lip for lid was done in PLA as well as the buttons to switch louvers from open to closed. Louver where printed in a Translucent blue for a good look when the light shines through. all pieces are printed with dove tail connection. model has been noched out for the front screen. Buttons where attached using M2x12 screws but shorter would be better, M2x4 is too short. Top lip for lid is marked at each joint with holes ranging from 1-8, match the joint with the same number of holes.Boost MePlease boost me so I can develop more needed accessories for others