Thingiverse
AnyCubic Kossel BLTouch Mount
von lokthelok
31
Downloads
10
Likes
0
Makes
This is a removable mount for a (slightly modified) AnyCubic Kossel.
The mount clips onto the end effector and holds a BLTouch underneath for delta calibration and mesh bed levelling. Two M3x5mm screws self tap into the under-size holes in the mount to attach the BLTouch.
The Fusion 360 model can be downloaded (and hence customised) here:
https://a360.co/2KeeqeZ
The Z-Offset for me was 49.50mm, but I have modified my Kossel with an E3D V6 hotend which sits higher up than the stock hotend.
I recommend measuring your offset as it will vary. The M114 (reports current XYZ) command is useful for this.
The mount clips onto the end effector and holds a BLTouch underneath for delta calibration and mesh bed levelling. Two M3x5mm screws self tap into the under-size holes in the mount to attach the BLTouch.
The Fusion 360 model can be downloaded (and hence customised) here:
https://a360.co/2KeeqeZ
The Z-Offset for me was 49.50mm, but I have modified my Kossel with an E3D V6 hotend which sits higher up than the stock hotend.
I recommend measuring your offset as it will vary. The M114 (reports current XYZ) command is useful for this.
lokthelok veröffentlicht auch auf
6 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
