Anycubic Kossel plus cable holder

**Update 2018-08-25:** Just updated the clip so that they are deeper and fit better into the Kossel frame. Now you should just be able to push the clip into the frame untill it stops and then take the two base pieces and push them together.


This is my cable holder for the hotend cable on my Anycubic Kossel Plus Linear.
I made it to fit inside the frame and releave the cable from strain when printing.

The idea with the design is to be able to slide the cable holder along the frame in any position you like.
This is why it is printed in 4 part. Two base part och two clips.

To install it you need to first push the clips into the frame and then take one half of the cable holder base and push the clips into it. Then after this is done add the cable and the second half of the cable holder base.

Test build everything outside the frame first is best.