Thingiverse
Anycubic linear power panel
von oldhui
50
Downloads
35
Likes
1
Makes
This is a power connection panel to the Anycubic linear plus.
The original power cables are screwed onto the controller board which is very inconvenient. I converted the whole thing to XT60 connectors as I am used to them with drones.
You will need 3* M3 screws and nuts to hold the XT60 connectors in place.
To mount the panel to the printer, I used another 4* M3 screw and nut sets, as I ran out of the original screws in the kit. The M3 screw back plates are only needed if you go for this DIY solution.
You may want to check out the other design of mine which gives 2 XT60 connector on the power supply.
The original power cables are screwed onto the controller board which is very inconvenient. I converted the whole thing to XT60 connectors as I am used to them with drones.
You will need 3* M3 screws and nuts to hold the XT60 connectors in place.
To mount the panel to the printer, I used another 4* M3 screw and nut sets, as I ran out of the original screws in the kit. The M3 screw back plates are only needed if you go for this DIY solution.
You may want to check out the other design of mine which gives 2 XT60 connector on the power supply.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
