Anycubic Mega Zero 2.0 Klipper config

Hi!
Here is the config I made from scratch for my Anycubic Mega Zero 2.0.
Mine has this upgrades on it, so config is made for this exact config:
- BTT Skr Mini MZ board
- BLTouch
- BTT Power off Relay 1.2 ( which is controlled by GPIO pin 17)
- And I have Hero Me Gen 5 gantry so change the X and Y offsets in [bltouch] block to add yours

The min and max positions are set for my exact config with belt tensionners etc, so perhaps you'll need to modifiy them by 1 or 2mm. At first power on and test, always keep finger on power off switch as always recommended.

The safe Z Home is set to be with probe dead center with my offset, so if in your case it's different, just change home_xy_position values

Same for The Screws tilt adjust ( equivalent of bed tramming in marlin) that is set to position the BLTouch exactly on bed screws position, with the offset of my hero me gantry, it can be different in you case, just adjust each points, it's easy in the config.

For the BTT Relay 1