Thingiverse
Anycubic Mega Zero BL Touch Mount
von qystan
57
Downloads
29
Likes
0
Makes
BL Touch installation mount.
Mounts over X_MIN limit switch using existing X_MIN limit switch screws.
Nozzle to Probe Offset values as follows:
NOZZLE_TO_PROBE_OFFSET{-37, -13, -2.195}
Please note that the Z will vary depending on your hot-end assembly.
Mounts over X_MIN limit switch using existing X_MIN limit switch screws.
Nozzle to Probe Offset values as follows:
NOZZLE_TO_PROBE_OFFSET{-37, -13, -2.195}
Please note that the Z will vary depending on your hot-end assembly.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
