Thingiverse
Anycubic Mega Zero - Direct drive mount basis
111
Downloads
99
Likes
4
Makes
This is a basis for a mount for a Direct Drive on the Anycubic Mega Zero 1.0/ 2.0 Gantry plate.
It fits onto the curved top of the Gantry plate and if needed you can use the existing to holes to fixate it with tie-wraps.
Originally it was requested in the MZ group, but I haven't heard feedback yet
https://www.thingiverse.com/groups/anycubic-mega-zero/forums/general/topic:49848
==
Update 29-07-2021 (Added Rev03). Thanks to feedback from Chris on FB, the DD mount has been updated so that the original extruder is the right way round. In the previous version the extruder was not orientated correctly. You could reverse the direction of the motor to make it work, but the extruder is less powerful then. In Rev03 this is not necessary and the extruder has sufficient power now.
It fits onto the curved top of the Gantry plate and if needed you can use the existing to holes to fixate it with tie-wraps.
Originally it was requested in the MZ group, but I haven't heard feedback yet
https://www.thingiverse.com/groups/anycubic-mega-zero/forums/general/topic:49848
==
Update 29-07-2021 (Added Rev03). Thanks to feedback from Chris on FB, the DD mount has been updated so that the original extruder is the right way round. In the previous version the extruder was not orientated correctly. You could reverse the direction of the motor to make it work, but the extruder is less powerful then. In Rev03 this is not necessary and the extruder has sufficient power now.
Calvin_MegaZero also publishes on
2 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
