Anycubic Photon Cover

This is a storage dust cover for my Anycubic Photon which can be used for carrying short distances. The lid can be used to block any direct sunlight which i have a problem with in the summer. The lid will only go past the perspex about 1cm due to the knob but that should be sufficient.

External Dimensions are 248x228x260 (Lid), 256x228x175 (Base).
I have only printed the base so far and at 25% infill it uses about 1kg of filament.
The top (25% infill) and Handle (100%) and straps (100%) will use about another 1.5kg.

I have made this for use with countersunk (4mm x 30mm) bolts and make sure that they do not protrude otherwise you will have scratches on your printer. The parts list you can see on the left of the main picture.

The holes in the top for the handle are 180mm apart to the middle of the bolts should you wish to use your own.