Anycubic Photon S Wall Mount

SummaryRemix to fit my Photon S powert supply, type TDX Power TDX-1206000.Made to fit the smaller powersupply and added vent holes. As an electrical engineer I am not a fan of enclosing PSUs with tight fitting holders... I have found them to last longer if they can get rid of their heat.Mount it using two 3x16mm (or longer) wood screwsEdit; Pretty much ignore v1, it is not quite the right. Size v2 is actually a tad lower (2mm) and longer (17mm) to better fit this type of PSU. I changed the width on the original design, but didn't check lenght and height... Doh!Print SettingsPrinter: FLSUN QQ-S Supports: Yes Resolution: 0.2 Infill: 15%Filament:Generic PLA