Thingiverse
Anycubic Photon Skin
by Ejnarwj
1
Downloads
0
Likes
0
Makes
This design consists of 2 pieces which will be blended together when printed.
1. Import the files and insure that they are completly aligned
2. Turn one of the pieces off and slice individually (Make sure to Z-retract of at least 2.5mm. Do not use Support. Do not use any raft or brim. Use a layer height of .25 mm )
3. Print the pattern part first and afterwards the other without removing the already printed.
4. Detach the old screen skin and apply your new.
1. Import the files and insure that they are completly aligned
2. Turn one of the pieces off and slice individually (Make sure to Z-retract of at least 2.5mm. Do not use Support. Do not use any raft or brim. Use a layer height of .25 mm )
3. Print the pattern part first and afterwards the other without removing the already printed.
4. Detach the old screen skin and apply your new.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
