Anycubic Predator Effector mod / Extruder mount

Since I am actually revamping my whole predator, I needed a plate between the extruder and the print head ( see image attached, the extruder hangs low over the print head without putting weight on it, but isn't swinging that hard anymore. Some additional rubber bands help taking away the vibrations, which are then led to the chassis, which again sits on rubber balls in a fitting. The result of this dampening is pretty darn crazy.

I also disassembled the print head, moved the metal plate up ( so it won't cool down the head as it does with the original conf ). Wrapped the coldend with some copper wire for better heat transportation, cut the pipe that goes into the coldend so I could lower the extruder way down to the printhead.

Added also some TL smoothers. Prior to all these changes, I couldn't get many successful prints, since a lot of heat issues, clogged nozzles etc were the norm.

Now, even with 0.2mm layers, prints look fine and very smooth. ( See pics ). Ghosting on the t