Anycubic Predator Enclosure Door

I made this end of 2020, I completely forgot to upload it. I think these are all of the files you will need, if I forgot something message me(can't say for sure if I'll see it seems that Thingieverse isn't sending me emails when people post any longer).

It's the same idea as NCNFN3D_Arts' door but I reduced the amount of parts, support and filament they you will need as well as made the doors easier to remove for PLA printing. You will need an assortment of m4 screws/nuts and glue to assemble the doors and t-nuts for the hinges, I do not recall the lengths but an assortment box should get you by. I used some weather stripping to seal the doors, this is optional and could cause heat creep issues if you use a hotend that cannot handle warmer ambient temps.

There is no latch, I just glued some tpu filament in the grooves on the top of the door, if the hinges are fitted correctly the TPU will make contact with the ceiling of the printer and hold the doors shut. It's worth noting th