Thingiverse
Anycubic Vyper Filament Guide
por 3DSeppi
106
Descargas
35
Likes
0
Makes
On my A-Vyper, I feed the filament from the bottom of a box. I designed the guide to bridge the angle. A PFTE tube can be fed through the hole. The filament is fed directly to the sensor.
The two holes on the filament holder can be used to fix the holder. However, this is not necessary due to the construction as the sensor sits sufficiently tightly in the guide.
I have already made several prints. It does what it should.
The two holes on the filament holder can be used to fix the holder. However, this is not necessary due to the construction as the sensor sits sufficiently tightly in the guide.
I have already made several prints. It does what it should.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
