Anycubic Vyper PTFE stabilizer bracket

I noticed that my strain gauge LED lights up whenever the print head moves to the right side of the gantry. This seems to because of pressure from the bowden tube. I decided to make a brace for the tubing. This should help with calibration, and may reduce wear on the strain gauge.

You will probably want to power cycle the printer after installing this. I think it calibrates the strain gauge on every boot. Once that's done, you may even want to re-level your bed to hopefully get a more accurate bed leveling mesh!

Printed on Anycubic Vyper, with PrusaSlicer, using Creality CR6-SE profile with modified bed size.

205C extruder temp, 60C bed temp
0.20mm layer height
15% infill
3 perimeters
seam position aligned
external perimeters first
avoid crossing perimeters
skirt height 1
Increased XYZE Jerk Values by about 80%
Retraction set to 3.5mm