Anycubic Wash and Cure Riser

WARNING : This is an abandonned project as I don't have the skills to make this a real thing, I've been using tinkercad only.

This is not usable, measurements are incorrect, ideas were :

- Rise the machine to a Longer Orange 30 height by adding ~2.5cm of height
- Allowing the cure plate to be stored in it, the pathway allowing to store the printed riser for said plate, I thought about adding an horizontal hole to store it but this way removing the plate would eject the riser too
- Do not block the ventilations holes at the bottom of the machine
- Only need 4 screw needed to put the feet under while holdint the printed part between the feet and the machine, this way vibrations shouldn't be an issue M4x30 seemed ok
- Print without support in 2 or 4 parts allowing printing on small buildplate

I believe there's not much left to be done :
- Put screw holes where they need to be
- Set the right size as it was measured with the bottom plate but machine width and length are not