Thingiverse
Apache 1800 latch
von aGard83
0
Downloads
0
Likes
0
Makes
I wanted to print colored latches to match the Ignite Firing System module color inside. Replicated the OE one , you just need to push the metal pin out of the case, from the handle side towards the outside and then put the new latch in and push the pin back into place.
I printed in PETG and printed with wall layers at 14 so the whole part is wall.
I printed in PETG and printed with wall layers at 14 so the whole part is wall.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
