Thingiverse
APC SMC1500I Bezel
by Madman1027
4
Downloads
4
Likes
0
Makes
APC SMC1500I Bezel
2x M3x20mm bolts required to piece the front together. I tapped the PLA to thread into and it's plenty strong enough.
I've yet to get around to filler/paint but the body of this is good enough to share for others to use.
The foam is merely air filter foam sheets from ebay
Supports only required for the bolt mounts, print the two bezel halfs face down
2x M3x20mm bolts required to piece the front together. I tapped the PLA to thread into and it's plenty strong enough.
I've yet to get around to filler/paint but the body of this is good enough to share for others to use.
The foam is merely air filter foam sheets from ebay
Supports only required for the bolt mounts, print the two bezel halfs face down
Madman1027 also publishes on
13 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!