Thingiverse
Aperture Science Coaster
von danyoud
16
Downloads
16
Likes
1
Makes
Aperture Science Drinks Coaster.
Made in Fusion 360. This is my first CAD model so go easy, though any constructive feedback is welcome.
I reduced the X and Y size to 85mm for the print in the photos so this does scale well, though it's probably best to keep the Z size at 5mm if you decide to scale up or down.
If the standard size is too big I might make this slightly smaller.
Please share photos if you decide to print it.
Made in Fusion 360. This is my first CAD model so go easy, though any constructive feedback is welcome.
I reduced the X and Y size to 85mm for the print in the photos so this does scale well, though it's probably best to keep the Z size at 5mm if you decide to scale up or down.
If the standard size is too big I might make this slightly smaller.
Please share photos if you decide to print it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
