Thingiverse
Apple Light
di Epicn8
7
Download
6
Likes
0
Makes
This apple is designed to fit over a Submersible LED Tea Light. The light is about 27mm wide but the hole is 31mm wide so the apple just sits over it without the light getting stuck inside.
Printed with supports overhang at 60 degrees.
Top layer must be at least 1.6mm thick. 0.8mm will result in a crack around the top. I believe the one in the picture was printed with 2.4mm top layer just to be safe.
Printed with 0% infill for nice lighting results. Wall thickness 0.8mm.
Apple stem is a tight fit. You can print both the apple and stem with Exclusive Tolerance if you want. I just trim mine down with a razor.
Tea lights found here:
https://www.amazon.com/Submersible-Waterproof-Underwater-Seasonal-Celebration/dp/B07H2ZTL3P
Printed with supports overhang at 60 degrees.
Top layer must be at least 1.6mm thick. 0.8mm will result in a crack around the top. I believe the one in the picture was printed with 2.4mm top layer just to be safe.
Printed with 0% infill for nice lighting results. Wall thickness 0.8mm.
Apple stem is a tight fit. You can print both the apple and stem with Exclusive Tolerance if you want. I just trim mine down with a razor.
Tea lights found here:
https://www.amazon.com/Submersible-Waterproof-Underwater-Seasonal-Celebration/dp/B07H2ZTL3P
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
