Thingiverse
Apple Magic Keyboard - Stand
by MikeInAZ
25
Downloads
19
Likes
0
Makes
These little stands are to give your Apple Magic Keyboard a bit of an angle instead of sitting flat on the table. It's about an 8 degree angle.
Print 2 of them and place on either side of your keyboard.
No supports, no rafts. Print in lower resolution to save time. On my MK3s it took exactly 1 hour to print 2 of them at .30 (draft).
Increase or decrease the size in your slicer if they aren't quite large enough for your particular keyboard.
Print 2 of them and place on either side of your keyboard.
No supports, no rafts. Print in lower resolution to save time. On my MK3s it took exactly 1 hour to print 2 of them at .30 (draft).
Increase or decrease the size in your slicer if they aren't quite large enough for your particular keyboard.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
