Apple Magic Keyboard Stand

This is a stand for an Apple Magic Keyboard. There are 3 files. The entire keyboard can be printed as one piece if your printer is big enough. There are also files for the left and right halves because the Ender 3 Pro is not large enough to print it in one piece. The keyboard sits high enough off the desk to allow for a wrist wrest. Download either the full keyboard STL or the left and right sides. If you print it in two pieces it is suggested you print some 3 or 4 mm high by 25 mm squares to act as alignment tabs and strengthen the joint.

This is best printed with the top of the keyboard laying flat on the bed. Since the top of the keyboard is an inclined plane make sure your slicer lays it flat on the bed.