Thingiverse
Apple Watch charger stand
door IanAdd
13
Downloads
4
Likes
0
Makes
My wife has an apple watch and the charger thing is always the wrong way up or falling off her bedside table so I created a solution.
The hole to insert the charger into is a tight fit after my printer built it but that is good, so wiggle a bit and push it in.
In case it was a loose fit there is a hole underneath which I had anticipated sticking a magnet in to hold it in place, so if your print leaves you with a loose fit that is the solution.
I just let my prusaslicer add supports and they are needed, obviously.
Enjoy.
The hole to insert the charger into is a tight fit after my printer built it but that is good, so wiggle a bit and push it in.
In case it was a loose fit there is a hole underneath which I had anticipated sticking a magnet in to hold it in place, so if your print leaves you with a loose fit that is the solution.
I just let my prusaslicer add supports and they are needed, obviously.
Enjoy.
IanAdd publiceert ook op
7 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
