Apple Watch Stand

Update 2021-09-29:
Rev 2 (two dots) adds designed-in support for the cable channel. A .4mm sacrificial wall is added to the inside curvature of the cable channel. Support easily peels away after printing - no more digging out support material.

When oriented on the print bed as shown in the .3mf file, the Bridge Angle is set to 45 degrees to minimize bridging travel length.


Original Post 2021-05-25:
This remix of evancli's excellent watch stand adds:
* A larger interior chamber in the base for lead shot.
* Small hole to aid in removing the charger.

After filling with lead shot, seal the hole with self-adhesive felt pad. Optionally, add a bit of epoxy to seal the shot hole.

With PrusaSlicer, I painted on supports for the cord slot and the top of the watch cavity. Depending on the filament, the cord slot supports can be difficult to remove.