Thingiverse
Apple Watch Stand
par Chiyetanka
10
Téléchargements
7
Likes
0
Makes
Remixed to isolate the watch stand. Thanks to [DIY_guy_3D] for original build!
Printed in Cura - Draft mode. No supports. See Pics.
It Works!
However, due entirely to my printing on lowest possible quality the result is a bit rough. I had a wad of thread inside the battery's circle seat, hard spot to sand smooth, so I just scraped it best I could (spend about 60 seconds on that :-) When I forcibly jammed the watch battery into the seat, the holder cracked (see pics.) But No Worries. Thanks to the sturdy 8mm width of these walls, that small crack hampers nothing.
I needed a watch stand asap. I got a watch stand asap. Thanks internet! Yr teh best!
Oh! And I recommend adding rubber feet to the bottom (https://www.amazon.com/dp/B06XCLYL53/) True for most all 3D printed table-top items. Just a heads up.
Printed in Cura - Draft mode. No supports. See Pics.
It Works!
However, due entirely to my printing on lowest possible quality the result is a bit rough. I had a wad of thread inside the battery's circle seat, hard spot to sand smooth, so I just scraped it best I could (spend about 60 seconds on that :-) When I forcibly jammed the watch battery into the seat, the holder cracked (see pics.) But No Worries. Thanks to the sturdy 8mm width of these walls, that small crack hampers nothing.
I needed a watch stand asap. I got a watch stand asap. Thanks internet! Yr teh best!
Oh! And I recommend adding rubber feet to the bottom (https://www.amazon.com/dp/B06XCLYL53/) True for most all 3D printed table-top items. Just a heads up.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
