Aquarium filter

Aquarium filter with a diameter of 110 mm and a height of 145 mm. The filter can be mounted on a hose with an internal diameter of 12-12.5 mm.Additional materials required:- 4 M4 Allen screws with a total length of 40 mm- 4 M4 nuts- 8 M4 washers (optional)- Suction cupThe filter consists of 4 parts:- Media container- Lid- Spacer basket, which should be placed at the very bottom of the filter, followed by filter media (of your choice)- Gaskets. If the printed gasket is not tight, you can replace it with a cut-out rubber gasket.When printing the media container on layer 1237, pause the print (this pause is added in the 3mf file) to insert the nuts and washers into the holes. Then continue printing.I recommend printing the seal with TPU and the rest with PETG. With the following settings:- 6 walls- 35% infill on outlines- 0.12mm layer height- You can also increase the flow rate by +0.1- Gap fillingThe filter printed this way is airtight. If it's not, you need to calibrate your printer