aquarium float switch holder

well I make no warranties or promises.. The 8mm bolt I used was from something else so you might want to cut it and make it smaller or do something different if you like. The bolt I also print that on my highest resolution setting. The rest was on the fast setting.. etc.

1) print 4 of the 1/4 pipe pieces. (may need to break up more if you can't print as tall). Glue them together with super glue or ABS juice. Then I spread ABS juice a couple of times around them to hopefully make them water proof. lol

2) I used a M10x1.5 thread cutter at the end of each tube and that seemed to work OK for my float switches but whatever works for yours.

3) I used a M8x1.25 thread cutter for for the on the main pipe holder body.

4) the pipe holder body had to be printed with supports and then the notch was cleaned out.

5) the M8 bolts here are probably too long I just had this model around and used it may want to tweak the bolt to your liking. I just use the bolt customizer.