Aquarium Lid Support

Very often I had a problem of not having the third hand to hold the lid of my aquarium while doing maintenance work in the tank. This thing is a solution for holding the lid up, which is very easy to install/uninstall and saves a lot of hassle.

This stand is designed to fit on a 0.7mm glass, so please make sure it will fit your before printing.

While printing you will have to use supports which are easy to remove.

Please note that there are two files, left and right. They are both needed for your aquarium since the lid is a bit bigger than the tank and goes over it by few millimetres.

The bottom of the hold ( the one attached to the glass ) is 15 cm long.
The one that goes up is 10 cm long.