Thingiverse
Aquarium water diffuser
von vdwel
20
Downloads
25
Likes
0
Makes
Since I use an oversized filter for my aquarium, te flow of water is to high with the standard outflow. This design diffuses the flow of water.
Print with PETG, supports on the build plate only for the tube.
Without the lid, you can still direct the flow into a specific direction.
The outer diameter is suitable for a 12/16mm hose or similar (I use it for my JBL outflow).
Print with PETG, supports on the build plate only for the tube.
Without the lid, you can still direct the flow into a specific direction.
The outer diameter is suitable for a 12/16mm hose or similar (I use it for my JBL outflow).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
