Thingiverse
AR-10 Wall mount V2.
von 609shadow
30
Downloads
36
Likes
0
Makes
Remixed from Explosion72 AR-15 Wall Mount.
Which was Remixed from ya3dpc's AR-15 Wall Mount.
I beefed up & sized up the design to accommodate the mag well and extra weight of a bigger piece to allow your AR-10 to be wall mounted. Also found a weak point on the back half where cracking would occur. Depending upon length I would recommend putting a support of some kind under the muzzle for xtra support. If I get enough free time/ motivation. I might make one up.
Which was Remixed from ya3dpc's AR-15 Wall Mount.
I beefed up & sized up the design to accommodate the mag well and extra weight of a bigger piece to allow your AR-10 to be wall mounted. Also found a weak point on the back half where cracking would occur. Depending upon length I would recommend putting a support of some kind under the muzzle for xtra support. If I get enough free time/ motivation. I might make one up.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
