MakerWorld
Sport & Outdoors
Zum Modell
AR Front Charging Handle
102
Downloads
59
Likes
31
Makes
This is a front charging handle design for AR patterned rifles It is designed to bolt directly onto the top picatinny rail, no rifle modifications requiredThis front charging handle is similar to the MP5 slap stick designThe middle support piece also acts as a bolt close hold down This model requires some additional hardware:6x M3 x 25mm screws and nuts0.25" OD dowel cut to length The dowel length will need to be cut specific to your placementI prefer to use carbon fiber tube from amazon, used for RC planes - its cheap, light, and strongDo not glue any of the components together. the dowel should be loose through all pieces so that the handle can twist freelyNo rifle modification is required - this should simply bolt on See model below specifically for 22LR AR patterned rifleshttps://makerworld.com/en/models/1361754-22lr-ar-front-charging-handle#profileId-1406615
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
