Thingiverse
AR wing pro HERO3 mount
von Dmitry_8266
11
Downloads
12
Likes
0
Makes
I remixed a blank nose cap to fit gopro hero3.
There are two holes in the front.
One is for M3 threaded inserts, you screw a bolt there to secure the camera. The second hole is there to push the on/off switch using the same hex key just used for the bolt.
No supports
There are two holes in the front.
One is for M3 threaded inserts, you screw a bolt there to secure the camera. The second hole is there to push the on/off switch using the same hex key just used for the bolt.
No supports
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!