ARB Awning Hooks 19+ Forester

I made some custom 3D printed ARB awning brackets/hooks that fit our 19+ foresters. The design is deployable. The 4 foot awning rides in the car. When you reach your destination you slide the feet into the aluminum groves. The back hook is taller, so switching the feet will let you mount it on either side of the car. There is a layer of gorilla tape where the hook touches the bar and single side foam tape where it touches the paint. The yellow picture shows a cross section of the hooks. I have used it on 4 occasions in the very hot sun. I used PETG filament. I am going to make a thingiverse page and share the design. Happy to answer any questions!Use plenty of top and bottom layers and also perimeters like the yellow picture.